Reports within 24 hours · Get your free instant quote
Certified Master Inspector sealCloser Look InspectorsStatewide Minnesota & IowaFree Instant Quote
Well Water Testing · Cold Spring, MN

Water testing in Cold Spring

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Get Your Free Instant QuoteSee What's Included
Cold Spring · Stearns County

Well Water Testing in Cold Spring

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Cold Spring is a granite-quarry town on the Sauk River with older homes and steady new growth. Housing here runs to older quarry-town homes and steady newer growth, across the older core near the Sauk River and the newer subdivisions.

Questions about a Cold Spring home?  ·  Call or text (612) 457-1634

Well water in Stearns County

MDA's 2014 and 2015 sampling covered many townships: the final dataset had 1,788 wells and 6.9% were at or over the 10 mg/L nitrate limit. Results ranged from 0% to 11.4%, and only Grove Township topped 10%, with the rest under 10%. MDH says central and west-central Minnesota show the highest shares of new wells with arsenic detections, so arsenic testing is sensible here.coli, nitrate, arsenic, lead, manganese, iron, hardness, pH, fluoride, sulfate, uranium, VOCs and DRO (diesel range organics) through an accredited lab.

County facts checked September 2026 against: Minnesota Department of Health, Minnesota Department of Health, Minnesota Department of Health, mda.state.mn.us, content.civicplus.com.

Water testing in Cold Spring: what matters

Cold Spring, MN water testing: hose bib on a brick wall at a Minnesota home in summer
Coliform bacteria: MDH recommends testing every year →
Small-town water tower in a small Minnesota town in winter snow (Stearns County, Minnesota)
Nitrate: EPA limit 10 mg/L, highest risk to infants →

Home inspection in Cold Spring →  ·  More about well water testing →  ·  Every water test, explained →

Pairs well with:

Septic inspection in Cold SpringRadon testing in Cold SpringSewer scope in Cold Spring

Water tests available in Cold Spring

Bacteria

Shows whether surface water or waste is reaching the well.

  • Total coliform bacteria
    Surface contamination reaching the well
    None should be present (MDH)
  • E. coli
    Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Nitrate
    Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Arsenic
    Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead
    Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Cold Spring private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

Nitrate in Stearns County wells

6.9%

6.9% of 1,788 wells tested in many townships were at or over the 10 mg/L nitrate standard (MDA township testing, 2014-2015).

Source: Minnesota Department of Agriculture township testing

Township numbers are averages. Only a test of your own well tells you its nitrate level. Get a free instant quote

What a properly finished wellhead looks like in Cold Spring

12 in. minimumabove groundground slopes awayvent screened, down
  • Casing at least 12 inches above the ground, slab or well house floor.
  • Vent ends at least 12 inches above ground, screened, opening facing down.
  • Ground graded so water drains away. A casing ending below ground, as in a well pit, is not allowed.
Source: Minnesota Rules 4725.2250 and 4725.5450

A short casing or a buried well pit lets surface water in. A coliform bacteria test shows whether it is reaching the water. Get a free instant quote

Buying a home with a well in Cold Spring: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Is nitrate high in Stearns County wells?
MDA's final dataset for townships sampled in 2014 and 2015 had 1,788 wells with 6.9% at or over the 10 mg/L limit. Only Grove Township exceeded 10% (11.4%), and every other township was under 10%. Results vary a lot by township, so MDH's advice to test nitrate every year applies to your own well.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
Does the granite under Cold Spring affect homes?
It can — shallow bedrock limits how deep basements and drainage can go, so foundation depth, sump performance and radon risk (granite country tests high) are best considered with that in mind.
Can I boil well water that tested positive for coliform?
MDH says boiled or bottled water can be used for drinking and cooking until the problem is fixed. However, do not boil the water if nitrate or arsenic was also detected, because boiling can increase their concentration. In that case use bottled water or another safe source until the well is treated and retested.
What is the safe level of nitrate in drinking water in Minnesota?
The EPA standard is 10 mg/L of nitrate measured as nitrogen, equal to 10 parts per million. It is based on protecting infants from blue baby syndrome. Natural processes usually keep drinking water below 3 mg/L, so higher results often point to a human-made source near the well.
How far must a well be from a lake, stream, or pond?
The minimum horizontal distance between a water-supply well and the ordinary high water level of a stream, river, pond, stormwater retention pond, or lake is 35 feet (Minnesota Rules 4725.4350). The distance does not apply to areas protected by a FEMA-accepted flood control structure, to wetlands, ditches, or depressions holding water under six months a year, or to artificial ponds under 5,000 gallons. If the wellhead is close to surface water, a coliform test is a reasonable check of how the water is holding up.
How can I tell if there is a forgotten well on my property?
The Department of Health suggests looking for a pipe 1 to 8 inches wide at, above, or below the surface, a low spot or sunken area, a metal, wood, or concrete cover, a windmill or old well house, and a concrete patch or glass block in a basement step or floor. Well pits and basement offsets are other common signs. Visible signs like these are worth raising with your agent and a licensed well contractor.
Keep looking

More across Minnesota.

Well Water Testing nearby

Other inspections in Cold Spring

Questions about well water testing

In-depth guides

Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote