Reports within 24 hours · Get your free instant quote
Certified Master Inspector sealCloser Look InspectorsStatewide Minnesota & IowaFree Instant Quote
Well Water Testing · Lonsdale, MN

Water testing in Lonsdale

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Get Your Free Instant QuoteSee What's Included
Lonsdale · Rice County

Well Water Testing in Lonsdale

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Lonsdale is a fast-growing small city of 2000s subdivisions south of the metro. Housing here runs to 2000s subdivisions with continuing growth, across the newer subdivisions.

Lonsdale is served by our Faribault team →  ·  (612) 457-1634

Well water in Rice County

MDA's 2017 township testing in Rice County covered Bridgewater, Cannon City, Morristown and Northfield: 478 wells were sampled, 5.6% initially at or over the 10 mg/L nitrate limit, and 1.6% of the 428 wells in the final dataset. Township results ran from 0% in Cannon City to 5.1% in Northfield. The MDA report says the St. Peter-Prairie du Chien-Jordan aquifer supplies most wells there and only about 5% draw from Quaternary aquifers. MDH adds that arsenic occurs statewide.coli, nitrate, arsenic, lead, manganese, iron, hardness, pH, fluoride, sulfate, uranium, VOCs and DRO (diesel range organics) through an accredited lab.

County facts checked September 2026 against: Minnesota Department of Health, Minnesota Department of Health, Minnesota Department of Health, mda.state.mn.us, ricecountymn.gov.

Well water around Lonsdale, Rice County

Lonsdale, MN water testing: glass carafe of water in morning light in a modern white Minnesota kitchen
Arsenic: about 10% of Minnesota wells exceed the standard →
Kitchen faucet with water droplets in a modern white Minnesota kitchen (Rice County, Minnesota)
Lead: MDH says no level is safe →

Home inspection in Lonsdale →  ·  More about well water testing →  ·  Every water test, explained →

Water tests available in Lonsdale

Bacteria

Shows whether surface water or waste is reaching the well.

  • Total coliform bacteria
    Surface contamination reaching the well
    None should be present (MDH)
  • E. coli
    Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Nitrate
    Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Arsenic
    Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead
    Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Lonsdale private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

Nitrate in Rice County wells

1.6%

1.6% of 428 wells tested in Bridgewater, Cannon City, Morristown and Northfield were at or over the 10 mg/L nitrate standard (MDA township testing, 2017).

Source: Minnesota Department of Agriculture township testing

Township numbers are averages. Only a test of your own well tells you its nitrate level. Get a free instant quote

Buying a home with a well in Lonsdale: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

How far a well must be from common hazards in Lonsdale

  • Building (closest projection)3 ft
  • Lake, river, stream or pond35 ft
  • Septic tank50 ft
  • Drainfield (soil dispersal area)50 ft (100 ft sensitive well)
  • Animal feedlot or building (over 1 animal unit)50 ft
  • Cesspool or seepage pit75 ft (150 ft sensitive well)
  • Unroofed feedlot, 300+ animal units100 ft
  • Unprotected petroleum tank, 1,100+ gallons150 ft
Source: Minnesota Rules 4725.4450 and 4725.4350

Septic, feedlot or fuel tank near the well? A coliform and nitrate test shows whether it is reaching the water. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Which aquifer do Rice County wells use?
MDA's Rice County report says most wells in the tested area draw from the St. Peter-Prairie du Chien-Jordan aquifer, which spans the whole testing area, and only about 5% draw from Quaternary aquifers. Its 2017 sampling found 1.6% of final-dataset wells at or over the nitrate limit. Well depth varies by property, so testing is still the check.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
What should Lonsdale buyers expect?
Mostly 2000s stock arriving at its first big replacement cycle — roofs, water heaters and furnaces all coming due within a few years of each other. Dating them accurately is the most useful thing the report does here.
How do I get nitrate out of my well water?
MDH recommends first having a licensed well contractor inspect the well and removing nitrate sources on your property. Home treatment can follow. MDH's guidance lists anion exchange, reverse osmosis, and distillation among options, and advises certified units. Babies under six months should still not drink treated water, and retest after treatment.
Should I test for E. coli when buying a house with a well?
A bacteria test is a standard way to check a private well, and CDC advises well owners to test for coliform bacteria and E. coli. Results reflect the day of sampling, and an accredited laboratory analyzes the sample. A positive result can be addressed through disinfection, retesting, and inspection of the well.
How far must a well be from a septic tank or drainfield?
Under Minnesota Rules 4725.4450, a water-supply well must be at least 50 feet from a septic tank and 50 feet from the absorption area of a typical soil dispersal system or a privy. Sensitive wells need more: 100 feet from the absorption area or privy. Distances are measured from the top of the well casing. A coliform and nitrate test shows whether nearby septic components are reaching the water.
How common is arsenic in Minnesota well water?
The Department of Health says about 40 percent of Minnesota wells have arsenic in the water. It occurs naturally in rocks and soil, levels can differ between wells even within a small area, and you cannot taste, see, or smell it. The EPA limit for community water systems is 10 micrograms per liter. Only a lab test shows the arsenic level in a specific well.
Keep looking

More across Minnesota.

Well Water Testing nearby

Other inspections in Lonsdale

Questions about well water testing

In-depth guides

Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote