Reports within 24 hours · Get your free instant quote
Well Water Testing · Shorewood, MN

Water testing in Shorewood

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Shorewood · Hennepin County

Well Water Testing in Shorewood

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Shorewood is a south-shore Minnetonka city of mid-century and custom homes on wooded lots. Housing here runs to mid-century and custom homes on wooded lots, across the south-shore neighborhoods and lake-access streets.

Shorewood is served by our Minnetonka team →  ·  (612) 457-1634

Old hand pump next to a modern well cap in Minnesota spring green: well water testing in Shorewood, MN
Coliform bacteria: MDH recommends testing every year →

Well water in Hennepin County

Hennepin County has no MDA township nitrate report on the schedule page, so there is no county well percentage to cite. MDH says about 10 percent of Minnesota private wells have arsenic above 10 ug/L, with levels varying over short distances, and that shallow and sand-aquifer wells are most exposed to nitrate. Boiling does not remove nitrate; it concentrates it. MDH lists coliform yearly, nitrate every year, and arsenic and lead at least once.

County facts checked September 2026 against: hennepincounty.gov, mda.state.mn.us, Minnesota Department of Health, Minnesota Department of Health, Minnesota Department of Health.

Water sample bottles in a small cooler with ice packs in a modern Minnesota kitchen: well water testing in Shorewood, MN
Lead: MDH says no level is safe →

Home inspection in Shorewood →  ·  More about well water testing →  ·  Every water test, explained →

Pairs well with:

Water tests available in Shorewood

Bacteria

Shows whether surface water or waste is reaching the well.

  • Surface contamination reaching the well
    None should be present (MDH)
  • Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Shorewood private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

How long a private well lasts in Shorewood

0255075100+ years
25 to 50 years is common
100+ possible

Wells built before 1974, when Minnesota's well code began, are listed by MDH as higher risk for bacteria, along with leaking dug wells, wells in old frost pits and wells with corroded casings.

Source: Minnesota Department of Health

Wells built before 1974 often have no record on file. Test the water before you close. Get a free instant quote

Buying a home with a well in Shorewood: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Do Hennepin County homes with private wells need arsenic testing?
MDH says about 10 percent of Minnesota private wells exceed 10 ug/L arsenic and that it can vary a lot between nearby wells, so it advises testing at least once.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
Do you cover Shorewood?
Yes — wooded sloped lots make grading, walkout-level moisture and shaded-roof wear the recurring items alongside the mid-century systems.
How do you remove arsenic from well water?
MDH lists reverse osmosis, distillation, anion exchange, and adsorptive media, plus oxidation or chlorination followed by filtration. Water softeners and activated carbon alone do not remove arsenic, and boiling concentrates it. Choose a unit certified by NSF International, UL, or WQA, and retest the water after installation.
Is there a safe level of lead in drinking water?
No. MDH states that there is no safe level of lead. The EPA action level of 15 parts per billion for public water systems is a point at which a utility must act, not a level considered safe. Babies, children under six, and pregnant women are at highest risk.
Why are abandoned or unused wells dangerous?
The Department of Health lists two kinds of risk. Children and small animals can fall into an open well, and equipment can break through a crumbling well or well pit. An unused well can also act like a drain, giving surface runoff, contaminated water, or waste a direct path into drinking water sources, including your own well. Annual water testing is one way to watch for contamination, as the Department of Health recommends testing annually where unused wells exist.
What should I look for on a well cap?
The Department of Health asks owners to check whether the well cap is securely attached, broken, or missing, whether the casing has cracks, holes, or corrosion, and whether electrical conduit and other connections are watertight. Under Minnesota Rules 4725.5450, a vent must be screened with openings of 1/16 inch or less and point downward. A damaged cap or vent is a good reason to test for coliform bacteria.
Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote