Reports within 24 hours · Get your free instant quote
Well Water Testing · Big Lake, MN

Water testing in Big Lake

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Big Lake · Sherburne County

Well Water Testing in Big Lake

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Big Lake is a Northstar-corridor lake town of 1990s-2000s subdivisions on sandy outwash. Housing here runs to 1990s-2000s subdivisions around the lakes, across the Big Lake and Mitchell Lake neighborhoods and the newer subdivisions near the Northstar station.

Big Lake is served by our Big Lake team →  ·  (612) 457-1634

Well cap in the foreground, 1970s rambler behind it in central Minnesota lake country in spring green: well water testing in Big Lake, MN
Coliform bacteria: MDH recommends testing every year →

Well water in Sherburne County

In MDA's township testing of six Sherburne townships sampled in 2014 and 2015, 7.5% of the 1,993 wells in the final dataset were at or over the 10 mg/L limit. Clear Lake and Haven townships topped 10%, and township results ran from 5.3% to 13.8%. Big Lake was 5.5%. Central Minnesota also has the highest arsenic-detection shares in new wells, per MDH, and MDH puts central counties among those with more homes on wells at increased nitrate risk.coli, nitrate, arsenic, lead, manganese, iron, hardness, pH, fluoride, sulfate, uranium, VOCs and DRO (diesel range organics) through an accredited lab.

County facts checked September 2026 against: Minnesota Department of Health, Minnesota Department of Health, Minnesota Department of Health, mda.state.mn.us, co.sherburne.mn.us, mndata.web.health.state.mn.us.

Well cap in the foreground, modern farmhouse with black windows behind it in central Minnesota lake country in summer: well water testing in Big Lake, MN
Nitrate: EPA limit 10 mg/L, highest risk to infants →

Home inspection in Big Lake →  ·  More about well water testing →  ·  Every water test, explained →

Pairs well with:

Water tests available in Big Lake

Bacteria

Shows whether surface water or waste is reaching the well.

  • Surface contamination reaching the well
    None should be present (MDH)
  • Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Big Lake private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

Nitrate in Sherburne County wells

7.5%

7.5% of 1,993 wells tested in six townships were at or over the 10 mg/L nitrate standard (MDA township testing, 2014-2015).

Source: Minnesota Department of Agriculture township testing

Township numbers are averages. Only a test of your own well tells you its nitrate level. Get a free instant quote

What a properly finished wellhead looks like in Big Lake

12 in. minimumabove groundground slopes awayvent screened, down
  • Casing at least 12 inches above the ground, slab or well house floor.
  • Vent ends at least 12 inches above ground, screened, opening facing down.
  • Ground graded so water drains away. A casing ending below ground, as in a well pit, is not allowed.
Source: Minnesota Rules 4725.2250 and 4725.5450

A short casing or a buried well pit lets surface water in. A coliform bacteria test shows whether it is reaching the water. Get a free instant quote

Buying a home with a well in Big Lake: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Which Sherburne County townships had the highest nitrate?
MDA's 2014 and 2015 sampling found Haven at 13.8% and Clear Lake at 11.3% of wells at or over the 10 mg/L limit, the only townships above 10%. Becker, Big Lake, Palmer and Santiago were between 5.3% and 8.6%. Countywide the final figure was 7.5%. Testing the specific well is still the only way to know.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
Is radon a concern in Big Lake?
Yes — sandy, highly permeable outwash soils move soil gas readily, and Sherburne County sits in EPA Zone 1. We recommend testing every home here, new construction included.
Should I test my well for VOCs if there is a gas station nearby?
MDH says to consider testing for volatile organic chemicals if your well is near fuel tanks or a commercial or industrial area. A nearby station is a reasonable reason to ask an accredited laboratory for a VOC analysis. Results are compared with MDH health-based guidance values for each compound.
How common is arsenic in Minnesota well water?
MDH reports about 10 percent of private wells in Minnesota have arsenic above the 10 µg/L standard, and arsenic was detected in about 40 percent of new wells drilled since 2008. Some wells have reached 350 µg/L. Levels vary between wells, even close together, so each well needs its own test.
Does a new well get tested for arsenic?
Yes. Minnesota Rules 4725.5650 requires the person constructing a new potable well to have a sample collected within 30 days, before the well is used, and analyzed for total coliform bacteria, nitrate-nitrogen, and arsenic. The Department of Health says contractors have tested new wells for arsenic since August 2008, and recommends owners test at least once beyond that initial test. A follow-up arsenic test gives a second data point, and MDH suggests retesting about six months after construction if arsenic was detected.
What should I look for on a well cap?
The Department of Health asks owners to check whether the well cap is securely attached, broken, or missing, whether the casing has cracks, holes, or corrosion, and whether electrical conduit and other connections are watertight. Under Minnesota Rules 4725.5450, a vent must be screened with openings of 1/16 inch or less and point downward. A damaged cap or vent is a good reason to test for coliform bacteria.
Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote