Reports within 24 hours · Get your free instant quote
Well Water Testing · Eagle Lake, MN

Water testing in Eagle Lake

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Eagle Lake · Blue Earth County

Well Water Testing in Eagle Lake

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Eagle Lake is a small growing town just east of Mankato. Housing here runs to mostly 1990s-2020s single-family homes and townhomes in newer subdivisions, around a small older core beside the lake, across the newer subdivisions along Highway 14 east of Mankato and the older lakeside core.

Eagle Lake is served by our Mankato team →  ·  (507) 721-3820

Well water in Blue Earth County

MDA's 2018 township testing in Blue Earth County covered five vulnerable townships and 642 tested wells, and 0.3% were over the 10 mg/L nitrate-nitrogen health standard. That is a low rate, but it is a township-scale sample, so your own well can differ. MDH says about 10 percent of Minnesota private wells exceed 10 ug/L arsenic, and levels can change a lot across short distances. MDH lists coliform yearly, nitrate every year, and arsenic and lead at least once.

County facts checked September 2026 against: blueearthcountymn.gov, mda.state.mn.us, mda.state.mn.us, Minnesota Department of Health, Minnesota Department of Health.

Home inspection in Eagle Lake →  ·  More about well water testing →  ·  Every water test, explained →

Pairs well with:

Water tests available in Eagle Lake

Bacteria

Shows whether surface water or waste is reaching the well.

  • Surface contamination reaching the well
    None should be present (MDH)
  • Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Eagle Lake private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

Nitrate in Blue Earth County wells

0.3%

0.3% of 642 wells tested in five vulnerable townships were at or over the 10 mg/L nitrate standard (MDA township testing, 2018).

Source: Minnesota Department of Agriculture township testing

Township numbers are averages. Only a test of your own well tells you its nitrate level. Get a free instant quote

Buying a home with a well in Eagle Lake: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

How far a well must be from common hazards in Eagle Lake

  • Building (closest projection)3 ft
  • Lake, river, stream or pond35 ft
  • Septic tank50 ft
  • Drainfield (soil dispersal area)50 ft (100 ft sensitive well)
  • Animal feedlot or building (over 1 animal unit)50 ft
  • Cesspool or seepage pit75 ft (150 ft sensitive well)
  • Unroofed feedlot, 300+ animal units100 ft
  • Unprotected petroleum tank, 1,100+ gallons150 ft
Source: Minnesota Rules 4725.4450 and 4725.4350

Septic, feedlot or fuel tank near the well? A coliform and nitrate test shows whether it is reaching the water. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Are Blue Earth County wells high in nitrate?
In MDA's 2018 results for five townships, 0.3% of 642 wells tested over the 10 mg/L health standard. That is a sample of certain townships, not a guarantee for one property.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
What is typical in Eagle Lake homes?
Eagle Lake is where Mankato's growth went, so most homes here are under 30 years old. That shifts the inspection toward builder details and settlement: grading pitched toward the foundation on former farm ground, backfill settlement cracks, attic insulation and ventilation shortcuts, disconnected ducts and mis-wired outlets. Lakeside lots get the drainage and water-table read. Blue Earth County is Radon Zone 1, and tight newer homes concentrate it, so a 48-hour test rides along on most visits.
Can I boil well water that tested positive for coliform?
MDH says boiled or bottled water can be used for drinking and cooking until the problem is fixed. However, do not boil the water if nitrate or arsenic was also detected, because boiling can increase their concentration. In that case use bottled water or another safe source until the well is treated and retested.
What is the safe level of nitrate in drinking water in Minnesota?
The EPA standard is 10 mg/L of nitrate measured as nitrogen, equal to 10 parts per million. It is based on protecting infants from blue baby syndrome. Natural processes usually keep drinking water below 3 mg/L, so higher results often point to a human-made source near the well.
Do I need to test my well after a flood?
Yes. The Department of Health says if flood water reached your well or covered the casing top, assume it is contaminated and do not use it for drinking, cooking, or brushing teeth until disinfection and a negative coliform test. If flood water came within 50 feet but did not reach the well, testing is advised as a precaution. A coliform test is the step that confirms the water after flooding.
How can I tell if there is a forgotten well on my property?
The Department of Health suggests looking for a pipe 1 to 8 inches wide at, above, or below the surface, a low spot or sunken area, a metal, wood, or concrete cover, a windmill or old well house, and a concrete patch or glass block in a basement step or floor. Well pits and basement offsets are other common signs. Visible signs like these are worth raising with your agent and a licensed well contractor.
Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote