Reports within 24 hours · Get your free instant quote
Certified Master Inspector sealCloser Look InspectorsStatewide Minnesota & IowaFree Instant Quote
Well Water Testing · Janesville, MN

Water testing in Janesville

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Get Your Free Instant QuoteSee What's Included
Janesville · Waseca County

Well Water Testing in Janesville

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Janesville is a small lake-side town between Mankato and Waseca. Housing here runs to small-town lake-side homes, across the lake-side neighborhoods.

Janesville is served by our Mankato team →  ·  (507) 721-3820

Well water in Waseca County

Waseca County did not appear on MDA's Township Testing results list, so no county nitrate percentage is quoted here. MDH says central and southeast Minnesota counties have more homes on wells at increased nitrate risk from row crops over sand-gravel or fractured bedrock aquifers, and that arsenic occurs statewide, with about 40 percent of new wells since 2008 showing a detection. MDH gives 100 µg/L as the manganese level for infant formula.coli, nitrate, arsenic, lead, manganese, iron, hardness, pH, fluoride, sulfate, uranium, VOCs and DRO (diesel range organics) through an accredited lab.

County facts checked September 2026 against: Minnesota Department of Health, Minnesota Department of Health, Minnesota Department of Health, mndata.web.health.state.mn.us, wasecacounty.gov.

Private wells and water systems around Janesville

Janesville, MN water testing: old hand pump next to a modern well cap in Minnesota spring green
Coliform bacteria: MDH recommends testing every year →
Water sample bottles in a small cooler with ice packs in a modern Minnesota kitchen (Waseca County, Minnesota)
VOCs: fuels, solvents and degreasers →
Janesville, MN water testing: water sample bottles with white caps on a counter in a Minnesota farmhouse kitchen
Nitrate: EPA limit 10 mg/L, highest risk to infants →

Home inspection in Janesville →  ·  More about well water testing →  ·  Every water test, explained →

Pairs well with:

Septic inspection in JanesvilleRadon testing in JanesvilleSewer scope in Janesville

Water tests available in Janesville

Bacteria

Shows whether surface water or waste is reaching the well.

  • Total coliform bacteria
    Surface contamination reaching the well
    None should be present (MDH)
  • E. coli
    Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Nitrate
    Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Arsenic
    Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead
    Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Janesville private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

How long a private well lasts in Janesville

0255075100+ years
25 to 50 years is common
100+ possible

Wells built before 1974, when Minnesota's well code began, are listed by MDH as higher risk for bacteria, along with leaking dug wells, wells in old frost pits and wells with corroded casings.

Source: Minnesota Department of Health

Wells built before 1974 often have no record on file. Test the water before you close. Get a free instant quote

Buying a home with a well in Janesville: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
What must a Waseca County seller file about the septic system?
Along with the Certificate of Real Estate Value, the Auditor's Office needs one of: a Certificate of Compliance, a Notice of Noncompliance, evidence of an escrow account, or an exemption form. Escrow is only allowed from November 1 to April 30.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
What is typical in Janesville homes?
Lake-side clay keeps groundwater high and drains slowly — a combination that shows up as basement moisture. Grading, drain tile and sump function deserve close attention, followed by the mechanicals and roof by age.
Should I test my well for VOCs if there is a gas station nearby?
MDH says to consider testing for volatile organic chemicals if your well is near fuel tanks or a commercial or industrial area. A nearby station is a reasonable reason to ask an accredited laboratory for a VOC analysis. Results are compared with MDH health-based guidance values for each compound.
How common is arsenic in Minnesota well water?
MDH reports about 10 percent of private wells in Minnesota have arsenic above the 10 µg/L standard, and arsenic was detected in about 40 percent of new wells drilled since 2008. Some wells have reached 350 µg/L. Levels vary between wells, even close together, so each well needs its own test.
How do I find the construction record for my well?
The Minnesota Well Index (MWI), maintained by the Department of Health, is an online database of basic well and boring information that can be searched by map or text. It is the web version of the County Well Index developed with the Minnesota Geological Survey. Most wells built before 1974 will not have records on file. Knowing the construction date helps decide what to test for.
How common is arsenic in Minnesota well water?
The Department of Health says about 40 percent of Minnesota wells have arsenic in the water. It occurs naturally in rocks and soil, levels can differ between wells even within a small area, and you cannot taste, see, or smell it. The EPA limit for community water systems is 10 micrograms per liter. Only a lab test shows the arsenic level in a specific well.
Keep looking

More across Minnesota.

Well Water Testing nearby

Other inspections in Janesville

Questions about well water testing

In-depth guides

Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote