Reports within 24 hours · Get your free instant quote
Certified Master Inspector sealCloser Look InspectorsStatewide Minnesota & IowaFree Instant Quote
Well Water Testing · Lexington, MN

Water testing in Lexington

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Get Your Free Instant QuoteSee What's Included
Lexington · Anoka County

Well Water Testing in Lexington

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Lexington is a small, dense postwar city of compact homes on quarter-acre lots. Housing here runs to small postwar homes on a tight grid, across the compact grid off Lake Drive.

Questions about a Lexington home?  ·  Call or text (612) 457-1634

Well water in Anoka County

MDA's township testing schedule lists no Anoka County report, so there is no county nitrate percentage to quote. MDH says shallow wells and wells in sand aquifers are the ones most exposed to nitrate, and that arsenic is elevated in central and west-central Minnesota and can differ sharply between neighboring wells because of glacial geology. MDH lists coliform bacteria yearly, nitrate every year, and arsenic and lead at least once.

County facts checked September 2026 against: anokacountymn.gov, anokaswcd.org, mda.state.mn.us, Minnesota Department of Health, Minnesota Department of Health, Minnesota Department of Health.

Water testing in Lexington: what matters

Lexington, MN water testing: well cap in the foreground, newer two-story home on a rural lot behind it in the Minnesota River valley in spring green
Coliform bacteria: MDH recommends testing every year →
Water softener with brine tank in an older fieldstone Minnesota basement (Anoka County, Minnesota)
Nitrate: EPA limit 10 mg/L, highest risk to infants →
Lexington, MN water testing: iron filter tank on the water line in an older fieldstone Minnesota basement
Lead: MDH says no level is safe →

Home inspection in Lexington →  ·  More about well water testing →  ·  Every water test, explained →

Water tests available in Lexington

Bacteria

Shows whether surface water or waste is reaching the well.

  • Total coliform bacteria
    Surface contamination reaching the well
    None should be present (MDH)
  • E. coli
    Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Nitrate
    Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Arsenic
    Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead
    Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Lexington private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

What a properly finished wellhead looks like in Lexington

12 in. minimumabove groundground slopes awayvent screened, down
  • Casing at least 12 inches above the ground, slab or well house floor.
  • Vent ends at least 12 inches above ground, screened, opening facing down.
  • Ground graded so water drains away. A casing ending below ground, as in a well pit, is not allowed.
Source: Minnesota Rules 4725.2250 and 4725.5450

A short casing or a buried well pit lets surface water in. A coliform bacteria test shows whether it is reaching the water. Get a free instant quote

Buying a home with a well in Lexington: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Is there county nitrate data for wells in Anoka County?
MDA's township testing program has not published a county report for Anoka County, so there is no county percentage to quote. MDH says shallow wells and wells in sand aquifers are most exposed to nitrate.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
Do you cover Lexington?
Yes — one of the metro's smallest cities, and its compact postwar stock gets the same full instrumented inspection as any larger suburb.
What is the safe level of arsenic in drinking water?
The EPA standard is 10 µg/L, equal to 10 parts per billion, though the EPA health goal is 0. MDH highly recommends taking action if a private well is above 10 µg/L, and notes that levels below the standard can still increase cancer risk over many years.
What is a first-draw lead test?
A first-draw sample is taken after water has sat in the plumbing for at least six hours, so it shows how much lead has dissolved from the plumbing. MDH also describes a flushed sample, taken after running the water for a minute or two. Use an accredited laboratory.
How far must a well be from a septic tank or drainfield?
Under Minnesota Rules 4725.4450, a water-supply well must be at least 50 feet from a septic tank and 50 feet from the absorption area of a typical soil dispersal system or a privy. Sensitive wells need more: 100 feet from the absorption area or privy. Distances are measured from the top of the well casing. A coliform and nitrate test shows whether nearby septic components are reaching the water.
How common is arsenic in Minnesota well water?
The Department of Health says about 40 percent of Minnesota wells have arsenic in the water. It occurs naturally in rocks and soil, levels can differ between wells even within a small area, and you cannot taste, see, or smell it. The EPA limit for community water systems is 10 micrograms per liter. Only a lab test shows the arsenic level in a specific well.
Keep looking

More across Minnesota.

Well Water Testing nearby

Other inspections in Lexington

Questions about well water testing

In-depth guides

Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote