Reports within 24 hours · Get your free instant quote
Certified Master Inspector sealCloser Look InspectorsStatewide Minnesota & IowaFree Instant Quote
Well Water Testing · Mayer, MN

Water testing in Mayer

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Get Your Free Instant QuoteSee What's Included
Mayer · Carver County

Well Water Testing in Mayer

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Mayer is a small Crow River town of older homes and fast 2000s subdivision growth. Housing here runs to older homes and fast 2000s subdivision growth, across the old core and the newer subdivisions.

Questions about a Mayer home?  ·  Call or text (612) 457-1634

Well water in Carver County

MDA's 2018 township testing in Carver County covered San Francisco Township, where 160 wells were tested and 2.5% were over the 10 mg/L nitrate-nitrogen health standard. That is one township, so treat it as a regional signal. MDH says arsenic runs about 10 percent above 10 ug/L statewide and can vary widely between nearby wells, and it lists coliform yearly, nitrate every year, and arsenic and lead at least once.

County facts checked September 2026 against: mda.state.mn.us, mda.state.mn.us, Minnesota Department of Health, Minnesota Department of Health.

Private wells and water systems around Mayer

Mayer, MN water testing: well cap beside a garden bed in Minnesota winter snow
Coliform bacteria: MDH recommends testing every year →
Steel well casing with vented cap in a lawn in Minnesota autumn color (Carver County, Minnesota)
E. coli: a sign of fecal contamination →
Mayer, MN water testing: well cap next to a red barn in Minnesota summer
Nitrate: EPA limit 10 mg/L, highest risk to infants →

Home inspection in Mayer →  ·  More about well water testing →  ·  Every water test, explained →

Pairs well with:

Septic inspection in MayerRadon testing in MayerSewer scope in Mayer

Water tests available in Mayer

Bacteria

Shows whether surface water or waste is reaching the well.

  • Total coliform bacteria
    Surface contamination reaching the well
    None should be present (MDH)
  • E. coli
    Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Nitrate
    Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Arsenic
    Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead
    Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Mayer private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

Nitrate in Carver County wells

2.5%

2.5% of 160 wells tested in San Francisco Township were at or over the 10 mg/L nitrate standard (MDA township testing, 2018).

Source: Minnesota Department of Agriculture township testing

Township numbers are averages. Only a test of your own well tells you its nitrate level. Get a free instant quote

How long a private well lasts in Mayer

0255075100+ years
25 to 50 years is common
100+ possible

Wells built before 1974, when Minnesota's well code began, are listed by MDH as higher risk for bacteria, along with leaking dug wells, wells in old frost pits and wells with corroded casings.

Source: Minnesota Department of Health

Wells built before 1974 often have no record on file. Test the water before you close. Get a free instant quote

Buying a home with a well in Mayer: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Is nitrate a problem for Carver County private wells?
MDA's 2018 initial testing in San Francisco Township found 2.5% of 160 wells over the 10 mg/L health standard. One township does not describe every property. Nitrate is only one item: MDH also recommends coliform bacteria every year and arsenic and lead at least once.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
What is typical in Mayer?
A split market — 2000s subdivision homes hitting their first roof and mechanical cycle, and an older core with original systems. We date everything so you can plan.
How does lead get into well water?
Lead is not usually in the well water itself. It enters through plumbing, most often lead pipes. Brass faucets and valves can release lead in their first months, some submersible pumps made before 1995 may contain leaded brass, and lead packers were used in wells drilled before 1980. Lead dissolves more the longer water sits in plumbing.
Can I boil well water that tested positive for coliform?
MDH says boiled or bottled water can be used for drinking and cooking until the problem is fixed. However, do not boil the water if nitrate or arsenic was also detected, because boiling can increase their concentration. In that case use bottled water or another safe source until the well is treated and retested.
Who regulates private wells in Minnesota, and who is responsible for the water?
The Department of Health licenses the contractors who construct, repair, and seal regulated wells, and administers the Well Code, Minnesota Rules chapter 4725. For an existing private well, the Department of Health says the owner is responsible for regularly testing the water and keeping it safe. Licensed contractors must file well records, and since 1974 the Department of Health has required submittal of well construction records. Water testing arranged by the owner fills that gap.
How can I tell if there is a forgotten well on my property?
The Department of Health suggests looking for a pipe 1 to 8 inches wide at, above, or below the surface, a low spot or sunken area, a metal, wood, or concrete cover, a windmill or old well house, and a concrete patch or glass block in a basement step or floor. Well pits and basement offsets are other common signs. Visible signs like these are worth raising with your agent and a licensed well contractor.
Keep looking

More across Minnesota.

Well Water Testing nearby

Other inspections in Mayer

Questions about well water testing

In-depth guides

Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote