Question 1

What is the difference between a manufactured home and a modular home?

Accepted Answer

The chassis, mostly. A manufactured home is built on a permanent chassis that assures its continued transportability, and that chassis is the dividing line between the two. A modular home is built in a factory, has no chassis, and is generally appraised, financed, insured and titled like a site-built house. Knowing which kind of home you are buying matters for the loan, the insurance and the title, so it pays to find out before you commit.

Question 2

Why does the manufactured-versus-modular distinction matter to my lender?

Accepted Answer

Because it changes the loan product. A modular home is generally appraised, financed, insured and titled as real property, essentially like a site-built house. A manufactured home may be titled as personal property on a vehicle title unless it has been converted to real property, which changes the loan type, the rate and the tax treatment entirely. Requirements vary by lender and loan program, so confirm the specifics with your loan officer — but knowing which kind of home you are buying is the first question to settle. The free instant quote on this page is the place to start a manufactured or modular home inspection.

Question 3

Is a mobile home the same as a manufactured home?

Accepted Answer

Not for legal or lending purposes. Homes built on or after June 15, 1976 are manufactured homes. Anything built before that date is a mobile home, and it is generally not eligible for FHA, VA, Fannie Mae or Freddie Mac financing and is often difficult to insure. Individual lender and portfolio-loan policies vary, so confirm with your loan officer — but which side of that date a home falls on is frequently the single most consequential fact about it, and you want to know before you are committed. If you are weighing an older home, the free instant quote on this page is a quick way to get a manufactured home inspection started.

Question 4

What if my lender asks for a foundation certification on a manufactured home?

Accepted Answer

If your lender asks for a foundation certification, it has to come from a licensed professional engineer — in some cases a registered architect — who issues a sealed letter. It is a separate document from the appraisal, and lenders commonly require it to be under six months old, so confirm the exact requirement with your loan officer. The conditions that will cause that certification to fail are no perimeter foundation, piers above frost depth, missing or failed anchoring, a damaged chassis, or the tow hitch and axles still attached. Finding them before the engineer does is the difference between fixing a list and failing a certification, which makes a manufactured home inspection the smart first step. Request the free instant quote on this page and mention the certification.

Question 5

Do manufactured homes in Iowa and Minnesota need tie-downs, and how do I know mine are right?

Accepted Answer

Yes. Anchoring is the part of a manufactured home most likely to be missing, corroded or loosened over time, and in a region with the straight-line wind and derecho history this one has, its condition is worth verifying. Anchoring is a safety margin, not a guarantee against a tornado or a derecho. A properly anchored home has anchors driven to full depth, straps within two feet of the ends of the home, and diagonal straps between 30 and 60 degrees. Severed, slack, rusted or missing straps and anchors pulled part-way out are the common problems. A manufactured home inspection is how you find out whether yours are right — start with the free instant quote on this page.

Question 6

Why does my manufactured home shift, crack and stick every winter?

Accepted Answer

Almost always because the footings or anchors do not reach below frost depth. The ground freezes and thaws every year here, so piers, footings and anchors set above the frost line lift in winter and drop in spring, and the home moves with them. Homes on blocks resting on grade heave every winter and drop every spring. A manufactured home inspection is how you find out where the footings and anchors really sit; the free instant quote on this page gets it started.

Question 7

What is a marriage line, and why is my floor uneven?

Accepted Answer

The marriage line, or mating line, is where the two halves of a multi-section home join. An uneven floor, a crack running the length of the home along that seam, or a ceiling gap that opens and closes seasonally usually points to the support system underneath rather than the seam itself — most often missing marriage-line or perimeter piers, or footings settling and heaving independently on each side. The gasket between sections, whether the line was ever sealed in the crawlspace and attic, and the ridge-beam connections matter too, because water entry at the ridge is a classic source of long-run interior damage. A manufactured home inspection is how you find the real cause. Request the free instant quote on this page to get started.

Question 8

What is belly wrap, and why does my manufactured home smell musty?

Accepted Answer

The belly wrap, or bottom board, is the membrane closing the underside of the floor system — the primary air and vapor control layer for the floor cavity and the rodent barrier. Punctures, sagging and missing sections are common past about 15 to 20 years. Once it fails, moisture saturates the floor insulation and raises the moisture content of the decking; above roughly 19 percent, rot and mold become active risks. A musty odor from the floor registers is the field symptom. The supply ducts run in that same belly, so they sag, separate, fill with water and sweat — and on a double-wide the crossover duct is very commonly found crushed or disconnected on the ground.

Question 9

Does a manufactured home need skirting, and does it need vents?

Accepted Answer

Skirting is not decorative — it encloses the crawlspace and is part of the home's moisture and thermal system, but it is not a foundation and must not be load-bearing. The enclosed space needs an access opening for service, plus either adequate ventilation openings or a properly sealed crawlspace with a continuous ground vapor retarder. Damaged skirting is the other half of the story: missing panels, buried skirting, and rodent entry, which in this region is constant and destroys belly insulation. Whether to vent or seal a crawlspace in a cold climate is a genuine technical debate, and the manufacturer's installation instructions for the home are the benchmark.

Question 10

Should I test for radon in a manufactured home?

Accepted Answer

Yes — the assumption that a home on piers cannot have radon is wrong. An enclosed, skirted crawlspace over bare soil is a radon reservoir, and the same torn belly wrap and duct, plumbing and crossover openings that let moisture into the floor cavity let soil gas into the living space, with winter stack effect driving it upward. The living area is what gets tested, not the crawlspace, since the crawlspace is not occupied space. Mitigation also differs: rather than sub-slab depressurization, the typical approach is sub-membrane depressurization under a sealed crawlspace vapor barrier, usually with bottom-board repair. In a park, ask whether the owner permits it before you test.

Question 11

Is aluminum wiring in an older mobile home a problem?

Accepted Answer

Solid aluminum branch-circuit wiring, used in homes and mobile homes from roughly 1965 to 1973, is a documented fire hazard and an insurance issue. The Consumer Product Safety Commission estimates about two million homes and mobile homes were built with aluminum wiring since 1965 and reports that homes with it are 55 times more likely to have a connection reach fire-hazard conditions than homes wired with copper. The failure is at the connections. Accepted repairs such as COPALUM crimps or AlumiConn connectors are licensed electrician work. Aluminum service-entrance and feeder conductors are a different matter entirely and are normal and acceptable.

Question 12

What should I know about the chassis, and can you inspect a park model?

Accepted Answer

The steel I-beam frame is permanent and structural, and its condition matters as structure: corrosion where a torn belly has exposed it to ground moisture, transport damage, bent outriggers, and unauthorized cutting or notching of the I-beams, often done to run plumbing or add a stair. For lending, the running gear — hitch, wheels and axles — generally has to be removed. A park model is a different animal: built as a recreational vehicle, generally under 400 square feet, titled as an RV, and typically not eligible for conventional mortgage financing. Whether one may be occupied year-round is a local zoning question.

Question 13

How much does a manufactured home inspection cost?

Accepted Answer

Scope drives it. A single-section home over a crawlspace is a different job than a multi-section home with a marriage line, a full perimeter foundation and a basement, and add-ons such as radon testing change it again. Access matters too — skirting that cannot be opened and a crawlspace that cannot be entered limit what can be inspected and what needs to be reported. Send us the address and a description of the home through the free instant quote request on this page and you will get a figure for that specific property.

Question 14

Is a house near the Fairgrounds any different to inspect?

Accepted Answer

The structure is the same, but the setting can affect it. How the lot drains matters, since parking and paved areas nearby can shed water toward a foundation, as do the condition of the exterior, trees and utilities. Crowds during the fair do not change the house itself. The main practical step is to view the property on a normal day and again in rain if you can.

Question 15

What is unusual about the University Grove houses in Falcon Heights?

Accepted Answer

University Grove is a neighborhood of 103 architect-designed houses, planned in 1928 on land the University of Minnesota set aside for faculty. Owners hold the houses while the university owns the land and charges annual ground rent. The houses run from traditional styles to midcentury modern. Flat and low-slope roofs, large window walls, and original wiring and heating equipment need close attention. Two-thirds of the city is public land, mostly the university and State Fair, so the homes are concentrated. Ramsey County is EPA Radon Zone 1.

Manufactured & Modular Home Inspection in Falcon Heights

Manufactured & Modular Home Inspection in Falcon Heights

Homes in Falcon Heights.

Local conditions in Falcon Heights

Manufactured & Modular Home Inspection in Falcon Heights: what matters

Common problem areas in manufactured homes

Common questions.

More across Minnesota.

Manufactured & Modular Home Inspection nearby

Other inspections in Falcon Heights

Questions about manufactured & modular home inspection

In-depth guides

Build your quote in 30 seconds.