Reports within 24 hours · Get your free instant quote
Certified Master Inspector sealCloser Look InspectorsStatewide Minnesota & IowaFree Instant Quote
Well Water Testing · Winsted, MN

Water testing in Winsted

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli…

Get Your Free Instant QuoteSee What's Included
Winsted · McLeod County

Well Water Testing in Winsted

Water testing for Minnesota homes, above all those on a private well. An accredited laboratory tests the water for coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. The Minnesota Department of Health recommends testing a private well for coliform bacteria every year, nitrate every year, and arsenic and lead at least once.

Winsted is a small lake-side town of older homes around Winsted Lake. Housing here runs to older lake-side homes, across the neighborhoods around Winsted Lake.

Winsted is served by our Big Lake team →  ·  (612) 457-1634

Faucet aerator close-up with clear water in a Minnesota lake cabin kitchen: well water testing in Winsted, MN
Lead: MDH says no level is safe →

Well water in McLeod County

McLeod County has no township nitrate report on MDA's results list, so no county-specific figure is available to quote here. What MDH does say applies statewide: arsenic is in groundwater everywhere, found in about 40 percent of new wells since 2008, and about 10 percent of private wells exceed 10 µg/L. MDH also says manganese is natural in Minnesota groundwater, and 100 µg/L is its safe level for infant formula. Nitrate and coliform bacteria are the yearly and every-other-year checks.coli, nitrate, arsenic, lead, manganese, iron, hardness, pH, fluoride, sulfate, uranium, VOCs and DRO (diesel range organics) through an accredited lab.

County facts checked September 2026 against: Minnesota Department of Health, Minnesota Department of Health, Minnesota Department of Health, mda.state.mn.us, mcleodcountymn.gov.

Refrigerator water dispenser filling a glass in a 1960s Minnesota kitchen: well water testing in Winsted, MN
Coliform bacteria: MDH recommends testing every year →

Home inspection in Winsted →  ·  More about well water testing →  ·  Every water test, explained →

Pairs well with:

Septic inspection in WinstedRadon testing in WinstedSewer scope in Winsted

Water tests available in Winsted

Bacteria

Shows whether surface water or waste is reaching the well.

  • Total coliform bacteria
    Surface contamination reaching the well
    None should be present (MDH)
  • E. coli
    Fecal contamination from septic, manure or wildlife
    None should be present (MDH)

Health chemicals

No taste, color or smell. These are the long-term health checks.

  • Nitrate
    Fertilizer, septic and manure; highest risk to infants
    10 mg/L (EPA)
  • Arsenic
    Natural arsenic from Minnesota rock and soil
    10 µg/L (EPA)
  • Lead
    Lead service lines, solder and brass fixtures
    No safe level (MDH)
  • Manganese
    Natural manganese; a concern for infants
    100 µg/L for infants (MDH guidance)
  • Fluoride
    Natural fluoride; dental health
    4.0 mg/L (EPA)
  • Uranium
    Natural radionuclide in groundwater
    30 µg/L (EPA)

Petroleum & solvents

Fuel and chemical spills from old tanks or nearby sites.

  • VOCs (volatile organic compounds)
    Fuels, solvents, degreasers and paints
    Varies by compound (EPA)
  • DRO (diesel range organics)
    Diesel and heating-oil petroleum
    No limit of its own; a petroleum screen (MPCA)

Household quality

Staining, scale and taste, and choosing the right treatment.

  • Iron
    Rusty staining and metallic taste
    0.3 mg/L, aesthetic (MDH)
  • Hardness
    Scale buildup; sizing a water softener
    No health standard
  • pH
    Corrosive or scaling water
    6.5 to 8.5, aesthetic (EPA)
  • Sulfate
    Taste and odor; diarrhea risk for infants
    250 mg/L, aesthetic (EPA)

Limits from MDH, EPA and MPCA. Compare your lab results with these values.

Winsted private well testing timeline

Minnesota Department of Health schedule: coliform bacteria and nitrate every year, arsenic and lead at least once. Source: MDH
TestYear 1Year 2Year 3Year 4Year 5Year 6
Coliform bacteria
Nitrate
Arsenic
Lead

When to test your water

  • Every yearColiform bacteria and nitrate, the basic safety checks for a private well. Nitrate can come from fertilizer, septic systems and animal waste.
  • At least onceArsenic and lead. Arsenic can differ even between neighboring wells.
  • Before a baby drinks the waterColiform bacteria, nitrate, arsenic, lead and manganese. MDH recommends testing a private well for all five before a baby drinks the water.
  • When you buy a homeA full baseline while you can still ask questions or negotiate.
  • After flooding or well workFlooding and repairs to the well are reasons to test again.
  • When taste, color or smell changesMDH says a change in taste, smell or look is a reason to test for coliform bacteria.
  • Near a fuel tank or industrial siteVOCs, plus DRO for diesel and heating oil. MDH says to consider a VOC test if the well is near fuel tanks or a commercial or industrial area.
  • City water in an older homeLead. MDH says homes built before 1940 may have lead service lines, and plumbing parts made before 1986 may contain lead.

Based on: MDH well testing, MDH coliform bacteria, MDH nitrate, MDH water for babies, MDH flood precautions, MDH lead.

How to get it done

  1. Choose your testsPick the water testing you need in the free instant quote.
  2. Pick a timeBook online. The quote takes about 30 seconds.
  3. Get certified lab resultsA certified laboratory analyzes the water and reports each result.

Get Your Free Instant Quote

Buying a home with a well in Winsted: the disclosure rules

  1. Before the purchase agreementThe seller discloses in writing every known well and whether it is in use, not in use or sealed.
  2. At closingA well disclosure certificate is signed, unless the deed says the seller knows of no wells.
  3. If a well was hiddenA seller who knew of an undisclosed well can owe the sealing cost and attorney fees if the buyer sues within six years.
Source: Minnesota Statutes 103I.235

The disclosure tells you a well exists, not what is in it. Add water testing to your inspection. Get a free instant quote

How far a well must be from common hazards in Winsted

  • Building (closest projection)3 ft
  • Lake, river, stream or pond35 ft
  • Septic tank50 ft
  • Drainfield (soil dispersal area)50 ft (100 ft sensitive well)
  • Animal feedlot or building (over 1 animal unit)50 ft
  • Cesspool or seepage pit75 ft (150 ft sensitive well)
  • Unroofed feedlot, 300+ animal units100 ft
  • Unprotected petroleum tank, 1,100+ gallons150 ft
Source: Minnesota Rules 4725.4450 and 4725.4350

Septic, feedlot or fuel tank near the well? A coliform and nitrate test shows whether it is reaching the water. Get a free instant quote

Questions

Common questions.

Who needs well water testing?
Any home on a private well, and above all when you are buying one. A private well is not regulated like a city water system, so the owner is responsible for knowing what is in the water. Testing before closing tells you whether the water needs treatment while you can still ask questions or negotiate.
What does the water panel cover?
The panel covers coliform bacteria and E. coli, nitrate, arsenic, lead, manganese, VOCs (volatile organic compounds), DRO (diesel range organics), iron, hardness, pH, fluoride, sulfate and uranium. Bacteria and nitrate are the short-term health checks. Arsenic, lead, manganese and uranium are the ones you cannot see or taste. VOCs and DRO screen for solvents and petroleum, such as fuel from an old oil tank or a nearby leak site. Iron, hardness, pH and sulfate explain staining, scale, odor and wear on plumbing and appliances.
How often should a well be tested?
The Minnesota Department of Health recommends coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Test again after flooding, after any work on the well, or if the taste, color or smell of the water changes.
Is well water testing part of the home inspection?
It is an add-on. Add it to your home inspection quote. Testing early in your inspection window leaves time to act on the results.
Which well tests matter most for a McLeod County home?
Follow MDH: coliform bacteria every year, nitrate every year, and arsenic and lead at least once. Add manganese, since MDH gives 100 µg/L as the safe level for infant formula. MDH says arsenic is found statewide, so a county without a published map result still needs a test. Buyers should test at inspection, not after closing.
My home is on city water. Is water testing still worth it?
Often yes. Community water systems follow EPA testing rules and report results in an annual Consumer Confidence Report, but that report does not measure your own plumbing. MDH and EPA say lead enters mainly from service lines and plumbing materials, and the only way to know is a tap test. MDH recommends an accredited lab, and your utility can say whether your home has a lead service line.
When should a home be tested for DRO or VOCs?
MDH suggests considering a VOC test when a well is near fuel tanks or a commercial or industrial area. MPCA reports petroleum has leaked at about 22,000 Minnesota sites, including home heating-oil tanks, and releases can threaten drinking water and send vapors into buildings. Reasons to test include a nearby leak site, a former or buried fuel tank, or a fuel odor or sheen. MPCA's leaking-tank-site database shows reported releases.
Do you cover Winsted?
Yes — and lake-side lots get particular attention on grading, water tables and lower-level moisture.
How often should I test my well for coliform bacteria in Minnesota?
MDH recommends testing private wells for coliform bacteria every year. It also recommends testing after any well work and after any change in the water's taste, smell, or appearance. Use an accredited laboratory, which can provide a sample container and instructions for collecting the sample.
How do I get nitrate out of my well water?
MDH recommends first having a licensed well contractor inspect the well and removing nitrate sources on your property. Home treatment can follow. MDH's guidance lists anion exchange, reverse osmosis, and distillation among options, and advises certified units. Babies under six months should still not drink treated water, and retest after treatment.
Does a new well get tested for arsenic?
Yes. Minnesota Rules 4725.5650 requires the person constructing a new potable well to have a sample collected within 30 days, before the well is used, and analyzed for total coliform bacteria, nitrate-nitrogen, and arsenic. The Department of Health says contractors have tested new wells for arsenic since August 2008, and recommends owners test at least once beyond that initial test. A follow-up arsenic test gives a second data point, and MDH suggests retesting about six months after construction if arsenic was detected.
What should I look for on a well cap?
The Department of Health asks owners to check whether the well cap is securely attached, broken, or missing, whether the casing has cracks, holes, or corrosion, and whether electrical conduit and other connections are watertight. Under Minnesota Rules 4725.5450, a vent must be screened with openings of 1/16 inch or less and point downward. A damaged cap or vent is a good reason to test for coliform bacteria.
Keep looking

More across Minnesota.

Well Water Testing nearby

Other inspections in Winsted

Questions about well water testing

In-depth guides

Free instant quote

Build your quote in 30 seconds.

No phone tag, no callback delay. Price and book your inspection right here — it takes about 30 seconds and there is no obligation.

Free Instant Quote & SchedulerPowered by InspectorData
Free Instant Quote